iogear smart card reader device cannot start code 10

IOGEAR SMART CARD READER DEVICE CANNOT START CODE 10 DRIVERS
IOGEAR SMART CARD READER DEVICE CANNOT START CODE 10 BLUETOOTH

The LED light on the Car Kit will light up during charging, and it will turn off when charge completes. Leave the Car Kit under sunlight exposure for 18 hours to have the device fully charged.

IOGEAR SMART CARD READER DEVICE CANNOT START CODE 10 BLUETOOTH

Place the Solar Power Bluetooth Car Kit under direct sunlight exposure with 45 degree angle, and have the solar panel facing toward sunlight.

Plug the car charger completely into the cigarette lighter in your car and turn on the power of your car. Plug the micro-USB connection end of the USB charging cable to the Solar Power Bluetooth Car Kit, and the other USB Type A connector end to the USB Type A female port of the included car charger. The LED light on the Car Kit will light up during char Plug the micro-USB connector end of the USB charging cable to the Solar Power Bluetooth Car Kit, and the other USB Type A connector end to any available SUB port on your computer or an AC power adapter with USB port (not included). MUTE Charging Your Car Kit Before you begin using your Solar Power Bluetooth Hands-free Car kit, it is recommended to fully charge the device to ensure optimal performance.

IOGEAR SMART CARD READER DEVICE CANNOT START CODE 10 DRIVERS

Some state laws prohibit drivers from using suction mounts on their windshields while operating motor vehicles. IMPORTANT NOTE: Before start using the Windshield Mount on your windshield, check the state and local laws and ordinances where you drive. Requirements Your mobile/cellular phone, PDA, or Smart Phone must be Bluetooth enabled and supports either Headset or Hands-free profile in order to work with the Solar Power Bluetooth Hands-free Car Kit.

Iogear smart card reader device cannot start code 10